Allied-telesis AT-8800 Series Switch Uživatelský manuál stáhnout pdf (Strana 103)

Layer 3 103

Software Release 2.6.1

C613-02039-00 REV A

Routing Information Protocol (RIP)

Routing protocols such as RIPv1 and RIPv2 can be enabled on a VLAN. For

example, to enable RIPv2 on the admin VLAN, use the command:

ADD IP RIP INTERFACE=vlan11 SEND=RIP2 RECEIVE=BOTH

To display information about RIP (Figure 23 on page 103), use the command:

SHOW IP RIP

Figure 23: Example output from the SHOW IP RIP command.

Novell IPX

The switch’s implementation of the Novell IPX protocol uses the term circuit to

refer to a logical connection over an interface, similar to an X.25 permanent

virtual circuit (PVC) or a Frame Relay Data Link Connection (DLC). The term

interface is used to refer to the underlying physical interface, such as VLAN,

Ethernet, Point-to-Point (PPP) and Frame Relay.

To create IPX circuit 1 with the Novell network number 129 over the admin

VLAN, use the command:

ADD IPX CIRC=1 INTERFACE=vlan11 NETWORK=129 ENCAP=802.3

To display information about the circuits configured for IPX (Figure 24), use

the command:

SHOW IPX CIRCUIT

Interface Circuit/DLCI IP Address Send Receive Demand Auth Password

-------------------------------------------------------------------------------

vlan11 - - RIP2 BOTH NO NO

ppp0 - 172.16.249.34 RIP1 RIP2 YES PASS ********

-------------------------------------------------------------------------------

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 117 118

Žádné komentáře

Allied-telesis AT-8800 Series Switch Uživatelský manuál Strana 103