Allied-telesis AT-FS708LE Uživatelský manuál stáhnout pdf (Strana 20)

Note

Since the AT-FS708LE ports operate in

Auto-Negotiate mode only, the end-nodes

connected to the AT-FS708LE must also

be configured to operate in the Auto-

Negotiate mode. If an end-node is

configured to a specific duplex in a

manual mode, it will not respond to the

Auto-Negotiate protocol from the

AT-FS708LE. (The speed is determined

from the link pulses, however, so the

speed is always detected correctly.) As a

result, the AT-FS708LE port setting will

end up at half-duplex. If the end port is

manually configured to full-duplex, there

will be a duplex mismatch and data will

be lost. If the end port is manual

configured to half-duplex, both ports will

have the speed and duplex match up

correctly.

Auto MDI/MDI-X

An RJ-45 twisted pair port on a 10 Mbps or 100

Mbps Ethernet network device can have one of

two possible wiring configurations: MDI or

MDI-X. A RJ-45 port on a PC, router, or bridge

is typically wired as MDI, while a twisted pair

port on a switch or hubs is usually MDI-X.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Žádné komentáře

Allied-telesis AT-FS708LE Uživatelský manuál Strana 20