Allied-telesis AT-FS203 Uživatelský manuál Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 50
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
AT-FS200 Series Installation Guide
17
Installing the Switch
To install the switch, perform the following procedures:
1. Remove all equipment from the package and store the packaging in a safe
place.
2. If you are installing the switch as a standalone unit, attach the four rubber
feet to the base of the unit, placing one rubber foot in each corner. (For
rack-mount chassis installation, do not attach the feet.)
3. Configure the DIP switches on the rear panel of the unit. Refer to Figure
11 and Figure 12 for the location of the switches and Table 6 and Table 7
for the possible settings.
Table 6
DIP Switch Settings for the AT-FS201 and AT-FS202 Switches
Port 2 1 2 2
Speed (Mbps) Duplex Mode Auto-neg Bytes
Up 10 Half Off 1522
Down 100 Full On 1518
Table 7
DIP Switch Settings for the AT-FS203 Switch
Port 1 2 1 2 1 2
Speed (Mbps) Duplex Mode Auto-neg (only) Bytes
Up 10 Half Off 1522
Down 100 Full On 1518
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 49 50

Komentáře k této Příručce

Žádné komentáře