Allied-telesis AT-8203 Uživatelský manuál stáhnout pdf (Strana 12)

Installing the Uplink Card

4. Remove additional hardware, such as rackmounting brackets.

Note

If the switch is installed on the desktop, you need not remove the

rubber feet.

Warning

Use proper static-free procedures prior to opening the unit and

touching components.

5. Remove the top cover from the unit, as follows:

a. Remove the screw from the back of the unit that locks the cover in

place. Retain the screw for replacing the cover later.

b. Lift the cover and slide it off (Figure 4).

Figure 4:

Chassis Top Removal

6. Using a #1 Phillips screwdriver, remove the screw that secures the

cover plate to the uplink panel (Figure 5).

Save the screw to secure the uplink card.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Žádné komentáře

Allied-telesis AT-8203 Uživatelský manuál Strana 12