Allied-telesis AT-FS705LE Uživatelský manuál stáhnout pdf (Strana 36)

Installation

• You should check to be sure that you are

using the appropriate type of twisted pair

cabling. Refer to Table 4 on page 10 for

twisted pair cable specifications.

• Since the twisted pair port, when operating

in Auto-Negotiation, is Auto MDI/MDI-X,

you can use either a straight-through or

crossover twisted pair cable to connect any

type of network device to a port on the

switch. If you disable Auto-Negotiation on

the port, the port defaults to MDI-X.

6. Apply power to the switch by plugging the

AC/DC power adapter into an AC power

outlet, the plug the DC connector to the power

receptable of the switch.

Warning

The power cord is used as a

disconnection device. To de-energize

equipment, disconnect the power cord.

 5

7. Verify that either the PWR LED is green. If

the LED is OFF, refer to “Troubleshooting” on

page 27 for instructions.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Žádné komentáře

Allied-telesis AT-FS705LE Uživatelský manuál Strana 36